Drilling Weeki Wachee What are the Toughest Drilling Conditions for Geotechnical Drilling?

/in , /by

Geotechnical drilling is something that is done in many locations, under drastically different geological and environmental conditions. This can cause individuals to see drilling professionals in many locations that they never thought it would be possible to perform geotechnical drilling. Weeki Wachee residents should know that although geological professionals are not always drilling for resources, often times the toughest drilling conditions and locations are related to oil drilling, specifically oil drilling off the coast in the middle of the ocean. This is because the water of the ocean creates issues that are not common in many other locations that geotechnical drilling can be performed at.

Hydrocarbons are at the Bottom of the Ocean

Drilling in residential areas for well construction or sinkhole investigations often times has professional drilling many feet down into the ground. This is the same logic with drilling for oil and natural gas in the ocean, but the deeper a geotechnical drilling company goes into the water, the more pressure that accumulates while drilling. Weeki Wachee residents should know that this is the major reason while humans have not been able to reach the deepest depths of the oceans without special equipment. Drilling professionals have to be extremely careful when drilling and installing a well to harvest these resources with that much pressure potentially.

A lot can Go Wrong if Deepwater Wells are Not Installed Properly

When a water well in a residential area is not installed correctly or is experiencing problems after a long stretch of time, the worst that can happen is a homeowner will have trouble getting water. When something is not installed correctly in the realm of Deepwater drilling, Weeki Wachee residents should know that it can be very dangerous and costly to many people involved. Harvesting oil and natural gas when done incorrectly can seep into the ocean water around the deep well and cause environmental issues. The killing of fish and other marine life does not only affect the ecosystem around the well, but it can have an adverse effect on many communities both on and off shore.

*Disclaimer: The views expressed here are those of the authors and do not necessarily represent or reflect the views of Amdrill Inc*

Geotechnical Drilling North Weeki Wachee What Structures Need Some Form of Marine Drilling?

/in , /by

If someone thinks that geotechnical drilling implies that these professionals only drill for stuff on land or deep within the Earth, they are wrong. Many coastal areas and bodies of water can be utilized for construction projects, either for personal use or a utilitarian purpose. Yet before that can happen, a team of professionals are going to be contracted to perform geotechnical drilling. North Weeki Wachee residents might not realize how many reasons or how many different types of structures need to first start from someone performing marine drilling in some body of water.

Fishing Piers

Most fishing piers no matter their size are often made out of wood. Yet you cannot simply place wood in the matter and expect it to be stable enough for a structure. With geotechnical drilling, North Weeki Wachee professionals would drill holes in the sea floor for a stable foundation you put posts for support. Some residential docks are constructed in this same manner if they are not the type that floats while be connected to a sea wall or other supportive object. Some boat ramps also need to have some form of marine drilling before they can be constructed.

Bridges

Bridges are not something people first think of when they think about marine drilling and related structures because the bridge is not in the water itself. Often times is it supported by concrete pillars that connect to the bottom of river or bay that they are going over. With geotechnical drilling, North Weeki Wachee professionals have to make sure these structures are secure enough and could wait for all the cars that will be driving over it. A birdge’s supports are very important for holding and distributing massive amounts of wait, and they are often the first major focus of any bridge construction project.

*Disclaimer: The views expressed here are those of the authors and do not necessarily represent or reflect the views of Amdrill Inc*

Geotechnical Drilling Weeki Wachee What is Water or Marine Drilling?

/in , /by

Although the prefix geo is a part of geotechnical drilling, Weeki Wachee residents should be aware that geotechnical drilling professionals are not only limited to drilling on land. With a little bit of modification to the drills and equipment, a drilling rig can easily maneuver into a water way and perform some aspect of drilling or sample collecting. A lot of people are under the impression that machines and water do not mix, but this is not true as many modern advancements have made it much easier to deal in water sites. Where may a water site be located for a geotechnical drilling professional?

Ocean and coastal Drilling

How do you think that water buildings get constructed such as a fishing pier or a boat dock? Someone has to construct this object, and every building needs a sturdy foundation and needs to know if a location is suitable for drilling. With geotechnical drilling, Weeki Wachee geotechnical drilling companies may be contracted for building projects that have to first drill into the soil and sediments underwater to make sure the building will be safe. In the water it is much harder to make sure a structure is sound as the soil conditions are not necessarily the same as land conditions.

Rivers and Lakes

It is also common for a geotechnical drilling company performing water drilling to be contracted for a project that involves a river or a lake. With geotechnical drilling, Weeki Wachee drilling professionals would most likely be constructing something like a bridge over the site, but it is possible they could be collecting samples for testing. Shallow bodies of water are most often going to be easier to work in and around instead of an ocean or coastal setting, but it all depends on the conditions below the surface of the water.

*Disclaimer: The views expressed here are those of the authors and do not necessarily represent or reflect the views of Amdrill Inc*