Drilling Belleair Bluffs What is the Ideal Drilling Environment for Professionals?

/in , /by

With modern ingenuity, geotechnical drilling is not something that takes many hours because it is done by hand. We have many types of drilling equipment that quickly and effectively make it possible to gain access to an underground location. Yet even though we use machines to perform geotechnical drilling, Belleair Bluffs residents should know that there are some environmental or geological conditions that can make drilling more difficult. This is why geotechnical drilling companies would prefer to work in certain environments as opposed to others. Here are some of the easiest places where geotechnical drilling can be performed without major issues.

Flat and Level Areas

Even though Florida is known for being a very shallow state with very few areas reaching close to one hundred feet, that does not imply that most of the state is flat. Hill and small land elevations are still common, especially the more inland you go, and these uneven environments can make it harder to perform geotechnical drilling. Belleair Bluffs professionals would prefer to work in areas that are flat and level, but that does not always mean it will be easier to drill in. For example, flat areas often are easier to drill into and reach water, because flat areas often lie closer to sea level or in coastal areas.

Areas that are Cleared of Vegetation and Debris

Even though drills are strong enough to break through many types of hard rocks and sediments depending on the equipment being used, it is extremely hard for geotechnical drilling professionals to drill in areas that are overgrown with vegetation like bushes and trees. Unfortunately, many areas in Florida are like this because much of the state is underdeveloped. So, when a company is contracted to perform geotechnical drilling, Belleair Bluffs drilling professionals often won’t start their task until the land has been cleared. Clearing out brush for new construction projects makes it easier for both people and vehicles to move around the location.

*Disclaimer: The views expressed here are those of the authors and do not necessarily represent or reflect the views of Amdrill Inc*

Geotechnical drilling Belleair Bluffs How Different Drill Bits Can Affect Geotechnical Drilling?

/in , /by

Geotechnical drilling Is not something that is done with only one drill bit and one drilling rig. Different conditions in the environment of a site, as well as conditions below the surface of the ground can dictate what kind of equipment a company would use while performing geotechnical drilling. Belleair Bluffs residents might be shocked to know about all the different conditions that could cause geotechnical drilling to be much more difficult or in some instances, near impossible to complete and in an appropriate time frame. Geotechnical drilling professionals often have to have many tools to react to any underground conditions that may be present.

Rocks and Sediment that are Very Strong

For many individuals a rock is rock no matter what the color of it is or its qualities, but this is far from the truth when performing geotechnical drilling. Belleair Bluffs geotechnical drilling professionals know that some rocks and sediments are so strong it can often break the drills and wear down drill bits if they are not using the correct equipment. Some sediments are so strong that they only way to drill through them is to used drill bits with titanium or diamond tips.

Sandy or Loose Soil Conditions

Having a rock or sediment be too hard for a drill bit is not the only problem that geotechnical professionals have to worry about when performing geotechnical drilling. Belleair Bluffs professionals drilling on locations also have to worry about rocks and sediments being too loose for drill bits to effectively drill through. When soil is deemed too loose, often because it is a very fine sand, the best course of action professionals can take is using boring equipment as opposed to drill bits. When soil is too losing to be drilled through, there is no way of getting a stable hole down to subsoil conditions to see what is going on.

*Disclaimer: The views expressed here are those of the authors and do not necessarily represent or reflect the views of Amdrill Inc*